DXE-ISO-PLUS-2 Ethernet RF Filters

ISO-PLUS Ethernet RF Filters are very effective EMI Suppressors that are quickly and easily connected inline on Cat5e or Cat6 network cables.

Their patented* design provides common mode RF interference and EMI noise filtering of radio frequencies from well below 1 MHz to over 100 MHz.

The ISO-PLUS filters are for use with Ethernet cables only. They are not to be used on other products that have an RJ-45 cable such as radio microphones, audio interfaces (SignaLink), etc.

Additionally, any cable used that supplies power over Ethernet will not work - the ISO-PLUS units do NOT pass DC voltages and do not support PoE (Power over Ethernet).

ISO-PLUS RF filters, installed on both ends of Ethernet cables, work 2 ways. 1st, they can mitigate RF interference caused to the Ethernet connected device. 2nd, they can reduce interference to radio receivers and other Ethernet devices that is caused by RFI or EMI generated by an Ethernet connected device.

ISO-PLUS filters are sold in pairs and are normally installed at each end of an Ethernet cable; one filter at the RJ-45 Ethernet plug of the first device and the other filter at the RJ-45 Ethernet plug of the second device.

Features

• Each ISO-Plus comes with one six inch shielded RJ-45 patch cable (colour may vary)

• Suppress EMI by reducing common mode RF interference to and from Ethernet cables

• Effective from well below 1 MHz through 100 MHz (including 160 through 6 meter Amateur bands)

• Support 10/100 Mbps Fast Ethernet and GbE Gigabit Ethernet with no effect on data signal or speed

• Work with Cat5, Cat5e, Cat6 and Cat6A cables with RJ-45 male connectors

• Provide common mode RF attenuation resulting in reduced or eliminated EMI or RFI